Range Rover (LM) V8-4398cc 4.4L (M62) (2003)
Seat Belt Tensioner: Service and Repair
Pre-Tensioner - Front Seat Belt
Pre-Tensioner - Front Seat Belt
Service Repair No - 76.73.75
Before disconnecting the battery, ensure all text and cautions in the battery disconnection section are observed.
WARNING: Always disconnect both battery leads before beginning work on the SRS system. Disconnect the negative lead first. Never reverse
connect the battery.
Remove
1. Make the SRS system safe.
2. Remove front seat.
3. Release 2 clips securing harness to pretensioner.
4. Disconnect multiplug from pretensioner.
5. Remove Torx bolt securing pre-tensioner to seat and remove pretensioner.
WARNING:
^
Store the airbag module or seat pre-tensioner, with the deployment side uppermost. If it is stored deployment side down, accidental
deployment will propel the airbag module with enough force to cause serious injury.
^
Store the airbag module or seat pre-tensioner in a designated storage area. If there is no designated storage area available, store in the
locked luggage compartment/loadspace area of the vehicle, and inform the workshop supervisor.
Refit
NOTE: If the SRS component is to be replaced, the bar code of the new unit must be recorded.
1. Fit pretensioner and tighten Torx bolt to 48 Nm (35 lbf.ft).
2. Connect pretensioner multiplug and secure harness with clips.
3. Fit front seat.
4. Connect battery leads, earth lead last.