Range Rover (LM) V8-4398cc 4.4L (M62) (2003)
Liftgate Window Glass: Service and Repair
76.31.22 Glass - Tailgate Upper
The following equipment is required:
-
Cutting wire and handles
-
Glazing knife
-
Glass replacement kit
-
Sealant applicator gun
-
Suction cups
-
A felt covered table or stand to support glass
Remove
1. Remove rear wiper arm.
2. Remove tailgate trim casing.
3. Remove tailgate inner side finishers.
4. Remove tailgate glass outer finisher.
5. Disconnect 3 multiplugs from tailgate glass.
6. Protect exterior body work adjacent to rear screen.
7. From inside vehicle, carefully cut through sealant securing lower edge of windscreen with a glazing knife. It is not practical to use a Kent knife as
the windscreen is very close to body.
8. If necessary, use cutting wire to cut through any remaining sealant securing top and sides of windscreen.
9. Attach suction cups and with assistance, remove windscreen and place on stand.
CAUTION: Lay glass on felt covered supports and be careful not to damage the obscuration band. Do not stand on edge as this can
cause chips which subsequently develop into cracks.