landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Campaign - Memory Seat Module Reconfiguration|Page 4390 > < Campaign - Memory Seat Module Reconfiguration|Page 4384
Page 1
background image

Memory Positioning Module: All Technical Service Bulletins
Campaign - Memory Seat Module Reconfiguration

No: Q091

Issue: 1

Date: 03 DEC 2009

THIS SERVICE ACTION IS VALID FOR A LIMITED TIME ONLY AND WILL EXPIRE 30 NOVEMBER 2011

SECTION: 419

SERVICE ACTION: Memory Seat Update

AFFECTED VEHICLE RANGE:
NOTE:

Verify VIN in DDW to verify Service Action applicability prior to undertaking any repairs.

Range Rover (LM)

VIN: AA310605 - AA314568 (specific VINs)
Model Year: 2010

CONDITION SUMMARY:

Situation: 

A limited number of 2010 model year Range Rover vehicles memory seat Electronic Control Units (ECU) will hold the Controller-Area Network (CAN)
bus awake if the vehicle ignition system is switched on within three seconds of adjusting the seat, leading to a battery drain of approximately 2.5 Amps
until the next ignition cycle. When the battery voltage goes below 8.5 volts the seat module goes off-bus. When the voltage recovers, the application
software is likely to lock up; this in turn will cause the CAN bus to stay awake, leading to a flat battery / non-start condition.

Action: 

Retailers are required to HOLD all affected vehicles in the above VIN range that are in their control and refrain from releasing the vehicles for new or
used vehicle sale pending completion of the rework action detailed in this Technical Bulletin. Vehicles must not be released until successful
reconfiguration of the Driver's Seat Control Module. Affected vehicles in the hands of owners should be repaired at the next available opportunity. At the
time of customer appointment, ensure that all outstanding service campaigns for each individual vehicle are identified and allocate sufficient time and
resources to complete all campaigns. For cars in Retailer inventory, this Service Action should be performed in conjunction with the vehicle
Pre-Delivery Inspection (PDI).

PARTS:

No parts necessary

TOOLS:

IDS with IDS-DVD119_V8.03 or later and Calibration File 20 or later
Midtronics PSC-550 Vehicle Power Supply

WARRANTY:

NOTE:

Always check DDW to verify that the vehicle is affected by this Service Action prior to undertaking any repairs. Repair procedures are under constant
review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always refer to DDW to obtain the latest repair

Campaign - Memory Seat Module Reconfiguration|Page 4390 > < Campaign - Memory Seat Module Reconfiguration|Page 4384