Range Rover (LP) V8-4.0L (1999)
/v8-4.0l/Page-949002.png)
1.
Locate the part number tag on the throttle body.
2.
If the part number on the label is not "MHB101890", go to "Campaign Label Installation" and perform label installation to identify that the vehicle
has been inspected. Claim Option 2.
3.
If the part number on the label is "MHB101890", complete the Recall repair.
RECALL REPAIR
1. If the part number tag reads "MHB101890," remove the throttle body following Workshop Manual procedure in Section 19.22.45.
2.
Disassemble throttle body as follows:
^
Remove the three water jacket screws.
^
Remove the water jacket cover.
^
Discard the cover, screws, washers and gasket.
CAUTION:
Metallic tools or abrasive material can cause damage to the gasket surfaces. Only liquid gasket remover should be used.
3.
Remove the remains of the old gasket from the throttle body using care not to damage the housing.
4.
Ensure the throttle body water jacket cover mating face is thoroughly clean.
5.
Install the gasket, cover and screws supplied in kit MGM000010K. (Figure 1)
6.
Tighten the screws to 4.0 - 4.5 Nm (35.4 - 39.8 lbf.in.).
7.
Apply the new identification label to the throttle body.
8. Verify that the mating faces of the throttle body and inlet manifold are clean and all gasket material is removed.
9. Refer to Workshop Manual Section 19.22.45 and install the throttle body using a new gasket (ERR6623).
10. Install coolant hoses using clamps previously removed.
WARNING:
