Range Rover (LP) V8-4.6L (2001)
Wheel Speed Sensor: Service and Repair
ABS Sensors - Rear
WARNING: If a sensor is removed for any reason, a NEW sensor bush must be fitted.
Remove
1. Raise the vehicle.
WARNING: Support on safety stands.
2. Remove road wheel.
3. Release sensor harness multiplug from clip. Disconnect multiplug.
4. Release sensor harness grommets from bracket. Withdraw sensor harness.
5. Remove 2 bolts securing sensor harness guard to axle. Release 2 harness clips from brake pipe.
6. Clean area around sensor to prevent ingress of dirt.
7. Using a suitable lever, prise sensor from bush.