Range Rover (LP) V8-4.6L (2001)
CAUTION:
The caliper MUST NEVER hang on the brake hose during the repair.
^
Release the caliper from the hub and tie aside
avoiding strain on the brake hose.
^
Remove the Allen screw securing the brake disc to the drive flange and remove the disc. (Figure 1)
^
Ensure the mating surfaces of the new disc and of the drive flange are clean.
^
Install a new disc (SDB000201) to the flange. Install Allen screw and tighten to 16 Nm (12 lbf.ft).
^
Position the caliper to the hub, install bolts and tighten to 110 Nm (81 lbf.ft).
3.
Perform step 2 on the alternate side brake disc.
4.
Refer to RAVE section 70.40.02 and install the new front brake pads (SFC500050).