Range Rover (LP) V8-4.6L (2001)
/v8-4.6l/Page-1691005.png)
3.
Inspect the full length of the rear wheel arch seam for pinholes / gaps. (Arrowed in Figure 9)
4.
Ensure the seam is clean and dry.
5.
Fill any holes / gaps with sealant.
6.
Ensure the sealant is pushed fully into the holes / gaps.
7.
Wipe off any excess sealant.
8.
Repeat for alternate side of the vehicle.
9.
Return the suspension to normal ride height.
REPAIR 6 - BODY SEAMS AND GROMMETS BEHIND THE TAIL LAMPS
1.
Refer to RAVE section 86.40.70 and remove both tail lamps.
2.
Inspect body seams behind the tail lamps for pinholes.
3.
Ensure the seams are clean and dry.
4.
Fill any holes I gaps with sealant.
5.
Wipe off any excess sealant.
6.
Ensure the grommets are fitted correctly to body. (Arrowed in Figure 10)
7.
Position the tail lamps and start the fastener screws.
8.
Apply sealant around the fastener openings. (Arrowed in Figure 11)
9.
Install the tail lamp fastener and wipe off any excess sealant.
