Range Rover County LWB (LH) V8-4.2L (1993)
Wheels: Procedures
Balancing
PRELIMINARY
CAUTION: It is essential that all wheel balancing is carried out off the vehicle. The use of on the vehicle balancing could cause component damage or
personal injury and MUST NOT be attempted.
NOTE:
^
Before attempting to balance a wheel and tire assembly clean all mud and dirt deposits from both inside and outside rims and remove existing
balance weights.
^
Remove stones from the tire tread in order to avoid operator injury during dynamic balancing and to obtain the correct balance.
^
Inspect tires for damage and correct tire pressures and balance according to the equipment manufacturer's instructions.
WEIGHT PLACEMENT
Wheel/Tire Cross Section
Clean area of wheel rim and attach adhesive balance weights in position shown.
Tape On Wheel Weight
Cut through rear face of weight strip to detach required weights.
CAUTION:
^
Use only the correct adhesive balance weights to avoid damage to the aluminium rim.
^
DO NOT attempt to use a steel wheel weight on an aluminium wheel.
STATIC BALANCE
Wheel Tramp: