landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Air Suspension - Droning Noise|Page 8573 > < Air Suspension - Pressure Switch Stuck OFF|Page 8567
Page 1
background image

Compressor/Pump: All Technical Service Bulletins
Air Suspension - Droning Noise

No:

60/03/99/NAS

Ref:
Issue:

1

Date:

06/09/99

EAS Compressor Noise

AFFECTED VEHICLE RANGE:

RANGE ROVER (LP)

Up to XA420550

SITUATION:

ELECTRONIC AIR SUSPENSION NOISE

A customer may complain of a droning noise from the front left corner of the vehicle. The EAS compressor may be the source of this noise. Compressor
noise can be the result of worn or deteriorated rubber mounts.

RESOLUTION:

REPLACE MOUNTS WITH NEW SPECIFICATION PARTS

Modified compressor mounts (RVL100000, RVL100010) have been developed, and have been factory installed in all vehicles after the above VIN.

^

The new mounts can be fitted without additional modification to vehicles produced between WA398798 and XA420550.

^

For vehicles produced before WA398798 a modified bracket (RQU100100) provides increased thread length required by the new rubber mounts.

PARTS INFORMATION:

RVL100000 Rubber Mount Front

Qty. 2

RVL100010 Rubber Mount Rear

Qty. 1

RQU100100 Compressor Bracket

Qty. 1 Required before WA398798

RVL100030 Flat Washer

Qty. 3

RVL100040 Nylon Spacer

Qty. 1

WARRANTY CLAIMS:

60.50.10

Time 0.35 hrs.
Replace rubber mounts only

60.50.89/29

Time 0.80 hrs.
Replace rubber mounts and bracket

FAULT CODE: J

Normal warranty policy and procedures apply

REPAIR PROCEDURE:

NOTE:

When removing the EAS compressor, retain the three mounting nuts and dished washers, noting their original orientation.

Air Suspension - Droning Noise|Page 8573 > < Air Suspension - Pressure Switch Stuck OFF|Page 8567