Range Rover County LWB (LH) V8-4.2L (1993)
Valve Body: Service and Repair
Valve Body
Valve Body
1. Place the vehicle on a suitable hoist or over a pit, open the hood and disconnect the battery leads.
2. From underneath the vehicle drain the transmission using a suitable container.
3. Discard the pan plug seal ring.
4. Remove the oil filler/level tube from the pan.
5. Remove the six retaining plates and bolts.
6. Remove the pan and discard the gasket.
7. Using a TX27 Torx bit undo the three bolts which hold the oil screen.
8. Using a TX27 Torx bit undo the remaining thirteen bolts retaining the valve body.
9. Clean the surfaces ensuring no damage has occurred to the mounting face of the case, using a lint-free rag.
10. Fit the new valve body ensuring the selector shaft locates into the gear shift fork and fit the thirteen bolts loosely by hand.