Range Rover County LWB (LH) V8-4.2L (1993)
^*
STC3244
Flange Assembly - Rear Output*
^
FTC4939
Seal - transfer box output
^
RTC6363
Seal - transfer box output flange spline
^
NY112041L
Nut - nyloc - M12
WARRANTY CLAIMS:
41.20.51
Time 1.05 hrs.
Replace Front Output Shaft Seal
41.20.54
Time 0.85 hrs.
Replace Rear Output Shaft Seal
FAULT CODE: N
Normal warranty policy and procedures apply
REPAIR PROCEDURE:
REAR SEAL REPLACEMENT
1.
Following instructions found in WSM section 41 remove rear drive shaft, parking brake drum, oil seal, and flange assembly.
CAUTION:
Use care in order to avoid damaging the seal installation area of the transfer gearbox.
2.
Lubricate new seal lip with transmission fluid and install seal using tool LRT-41-013.
3.
Carefully clean any oil found on the parking brake backing plate, shoes and drum.
CAUTION:
A new style flange must be installed on the front output shaft when replacing the seal.
4.*
Install new output flange.
5.
Replace rubber-sealing washer with transfer box output flange spline seal RTC6363.
6.
Fit washer and Nyloc nut finger tight.*
7.
Install parking brake drum and secure to flange with screw.
8.
Adjust parking brake shoes and apply parking brake.
9.
Tighten Nyloc nut to 220 Nm. (162 lbf.ft).
10.
Reinstall remaining components as described in WSM section 41.
FRONT SEAL REPLACEMENT