Range Rover SE (LP) V8-4.0L (1995)
2)
Select the Dynamic Tests icon then the Heights and Valves icon. Monitor the actual height output of each sensor, paying particular attention to
those that flagged a fault. With the vehicle stationary, every sensor's output should be stationary and within the range defined below.
3)
If any sensor's output fails the above, remove it from the vehicle and inspect it for moisture ingress. This can be done by shaking the sensor close
to your ear and listening for a sloshing sound. Replace any sensor found to have water in it.
Ride state
Front Sensor
Rear Sensor
Range (bits)
Range (bits)
High
120-180
105-150
Standard
95 - 150
85 - 130
Low
75-140
75-120
Access
50-110
50-100
IMPORTANT:
On Range Rover 4.0 SE, you must turn the ignition off as instructed after performing a calibration. Failure to do so will not allow TestBook to clear
the 'Corrupt Sensor Data' fault code. If this happens, the calibration procedure must be repeated and the ignition must be turned off when instructed.
WARRANTY
Normal warranty policy and procedure apply
COMP. CODE
5Z1Z
SRO
60.36.01 - Height sensor front renew - 00.45 hr
60.50.37 - Re-calibrate EAS - 0.65 hr
60.50.42 - Diagnostic check - EAS using TestBook - 0.50 hr