Range Rover SE (LP) V8-4.0L (1995)
^
Install new nut and tighten to 135 Nm (100 lbf. ft.).
5.
Using a dial indicator check the drive flange.
Maximum permissible run out
0.010 mm (0.004 inches)
Face run out
0.010 mm (0.004 inches)
NOTE:
Run out and face run out may be optimized by removing the drive flange and rotating it through 180 degrees prior to refitting.
6.
Reinstall driveshaft with bolts and new nuts. Tighten to 48 Nm. (35 lbf. ft.).
7.
Replenish axle oil (GL4, GL5).
8.
Mark nose of differentials with marker supplied.
9.
Road test vehicle and check for leaks.
WARRANTY:
Normal warranty procedures and policies apply.
COMP.CODE:
4S1N
4S5N
SRO:
51.20.01 - Time: 0.55 hr.
Rear Pinion Seal Replacement
54.10.20 - Time: 0.55 hr.
Front Pinion Seal Replacement