Range Rover SE (LP) V8-4.0L (1995)
/v8-4.0l/Page-1856004.png)
13. Using LRT-99-500 if necessary, withdraw flange from transfer box. Collect sealing washer.
14. Remove dust shield.
15. Lever seal from location in casing.
CAUTION: Ensure seal location does not become damaged.
INSTALLATION
16. Ensure mating faces are clean.
17. Lubricate seal lip with transmission fluid.
18. Install seal using LRT-41-011.
19. Position dust shield.
20. Position flange. Install sealing washer.
21. Install flat washer and new Nyloc nut, finger tight.
22. Position brake drum. Secure to flange with screw.
23. Adjust park brake shoes.
24. Apply Handbrake.
25. Tighten flange nut to 148 Nm (109 ft. lbs.).
26. Position propeller shaft flange on brake drum. Align marks.
