Range Rover Sport (LS) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-847001.png)
Engine Oil Cooler Thermostat: Service and Repair
Auxiliary Oil Cooler Thermostat
Service Repair No - 12.60.17
Removal
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Disconnect the battery ground cable.
3. Remove the radiator access panel.
^
Remove the 4 bolts.
4. NOTE: Some fluid spillage is inevitable during this operation.
Remove the thermostat.
^
Position an absorbent cloth to collect fluid spillage.
^
Remove the 2 bolts.
^
Remove and discard the O-ring seal.
Installation
1. Install the thermostat.
^
Clean the component mating faces.
^
Install a new O-ring seal.
^
Install the bolts and tighten to 10 Nm (7 ft. lbs.).
2. Install the radiator access panel.
^
Install the 4 bolts and tighten to 10 Nm (7 ft. lbs.).
3. Connect the battery ground cable.
