Range Rover Sport (LS) V8-4.2L SC (2006)
exhaust or driveshaft.
2. Install the heat shield.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
3. Position the RH catalytic converter to the exhaust manifold.
^
Clean the components.
^
Tighten the new bolts to 22 Nm (16 ft. lbs.).
4. Position the LH catalytic converter to the exhaust manifold.
^
Clean the components.
^
Tighten the new bolts to 22 Nm (16 ft. lbs.).
CAUTION: Make sure there is a clearance (A) of 25 mm to 30 mm between the closest points of the LH catalytic converter and the front
driveshaft.