landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Throttle Body Gasket|Page 5918 > < Throttle Body Gasket
Page 2
background image

7. Disconnect the throttle position (TP) sensor electrical connector.
8. Release the throttle body.

^

Remove the 4 bolts.

^

Remove and discard the throttle body gasket.

Installation

1. Install the throttle body.

^

Clean the components.

^

Install a new gasket.

^

Tighten the 4 bolts to 10 Nm (7 ft. lbs.).

2. Connect the TP sensor electrical connector.
3. Secure the wiring harness clip.
4. Clean the component mating faces.
5. Install the throttle body intake.

^

Align the bushing.

^

Secure the clip.

Throttle Body Gasket|Page 5918 > < Throttle Body Gasket