landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Fuel Pump Relay > < Diagram Information and Instructions|Page 4122
Page 1
background image

Fuel Pump Control Unit: Service and Repair

Fuel Pump Driver Module (FPDM)

Removal

1. Disconnect the battery ground cable.
2. Remove the LH lower rear quarter trim panel.
3. Remove the FPDM.

^

Remove the 2 bolts.

^

Disconnect the electrical connector.

Installation

1. Install the FPDM.

^

Install the bolts and tighten to 10 Nm (7 ft. lbs.).

^

Connect and secure the electrical connector.

2. Install the rear quarter trim panel.
3. Connect the battery ground cable.

Fuel Pump Relay > < Diagram Information and Instructions|Page 4122