Range Rover Sport (LS) V8-4.2L SC (2006)
32. LH side: Attach the engine compartment ground cables.
^
Secure the clips.
^
Tighten the nuts to 25 Nm (18 lb.ft).
33. LH side: Connect the ABS electrical connector.
34. LH side: Attach the air suspension pipes.
^
Secure the clips.
35. LH side: Attach the body panel ground cables.
^
Tighten the nut to 25 Nm (18 lb.ft).
36. LH side: Connect the body panel electrical connectors.
37. LH side: Connect the adaptive front lighting module electrical connector.
38. LH side: Connect the washer jet hose.
39. Passenger side: Connect the transfer case electrical connector.
40. Passenger side: Connect the engine wiring harness electrical connector.
41. Install the headlamps.
42. Install the fender splash shields.
43. Attach the BJB wiring harness to the bulkhead.
^
Connect the electrical connectors.
^
Install the grommet.
44. Install the battery ground cable.
^
Attach the additional ground cable.
^
Tighten the nut to 25 Nm (18 lb.ft).
45. Secure the BJB to the bracket.
^
Tighten the bolt to 6 Nm (4 lb.ft).
46. Connect the heater motor electrical connector.
47. Connect the ground cables to the lower A-pillar.
^
Tighten the nut to 10 Nm (7 lb.ft).
48. Install the CJB bracket.
^
Tighten the nuts to 10 Nm (7 lb.ft).
^
Secure the clips.
^
Connect the electrical connectors.
^
Tighten the bolts to 25 Nm (18 lb.ft).
49. Install the CJB.
50. Connect the battery positive cable to the BJB.
^
Tighten the nut to 25 Nm (18 lb.ft).
51. Install the BJB cover.
^
Secure the clip.
52. Install the ECM.
^
Install the ECM top cover.
53. Install the ECM cover.
^
Tighten the Torx screws.
^
Connect the electrical connectors.
54. Install the auxiliary battery tray.
55. Install the battery tray.
56. Install the four-wheel drive control module.
57. Install the air cleaner assembly.
58. Install the radiator grille.
59. Install the engine cover.
60. Connect the battery ground cable.