Range Rover Sport (LS) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-419002.png)
6. Remove the intake air temperature (IAT) sensor.
^
Disconnect the electrical connector.
^
Remove the 2 Torx screws.
^
Remove and discard the O-ring seal.
Installation
1. Install the IAT sensor.
^
Clean the components.
^
Install a new O-ring seal.
^
Tighten the Torx screws to 6 Nm (4 ft. lbs.).
^
Connect the electrical connector.
2. Secure the supercharger pressure relief actuator.
^
Tighten the bolt to 10 Nm (7 ft. lbs.).
3. Install the throttle body intake.
^
Align the bushing.
