Range Rover Sport (LS) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-2028003.png)
11. CAUTION: If the ignition lock cylinder and switch are both removed from the ignition switch assembly, the assembly shaft MUST NOT be
rotated. Failure to comply will cause the incorrect operation of the lock, and the assembly must be replaced.
NOTE: Do not disassemble further if the component is removed for access only.
Remove the ignition lock cylinder.
^
Turn the ignition key to position 1.
^
Insert a pin, not exceeding 2 mm diameter, through the access hole in the ignition lock cylinder housing to depress the plunger, and release
the ignition lock cylinder.
12. Remove the ignition switch.
^
Depress the 2 clips.
Installation
1. Install the ignition switch.
^
Secure with the clips.
2. Install the ignition lock cylinder.
^
Turn the ignition key to position 1.
^
Locate into guides and depress the plunger.
