Range Rover Sport (LS) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-1670001.png)
Shifter A/T: Service and Repair
Selector Lever Assembly
Selector Lever Assembly
Service Repair No - 44.15.04
Removal
1. Disconnect the battery ground cable.
2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
3. Remove the transmission undershield.
^
Remove the 6 bolts.
4. If installed, remove the transmission heat shield.
^
Remove the 4 bolts.
5. Release the selector cable.
^
Using an additional wrench, restrain the clamping bush and loosen the locknut.
^
Compress the latch and release the cable.
6. Remove the floor console upper panel.
7. Release the transmission selector lever.
^
Disconnect the electrical connector.
^
Remove the 4 bolts.
8. Remove the transmission selector lever mount bracket.
^
Remove the 4 bolts.
