Range Rover Sport (LS) V8-4.4L (2009)
Hood Sensor/Switch (For Alarm): Service and Repair
Hood Switch
Service Repair No - 86.77.20
Removal
1. Disconnect the battery ground cable.
2. Release the RH hood latch.
^
Remove the 2 Torx bolts.
^
Disconnect the electrical connector.
3. Remove the hood switch.
Installation
1. Install the hood switch.
2. Install the RH hood latch.
^
Connect the electrical connector.
^
Tighten the Torx bolts to 10 Nm (7 lb.ft).
3. Open and close the hood to check the hood latch operation.
4. Adjust the hood latch.
^
Loosen the 2 hood latch Torx bolts.
^
Lower the hood and check for alignment.
^
Open the hood and tighten the Torx bolts to 10 Nm (7 lb.ft).
^
Check for the correct operation of the hood safety catch.
^
If necessary, repeat the above adjustment procedure.