Range Rover Sport (LS) V8-4.4L (2009)
6. NOTE:
^
Do not disassemble further if the component is removed for access only.
^
Note the fitted position.
Remove the glass retaining clip.
^
Remove the Torx bolt.
^
Remove the spacer washer.
^
Remove the flat washer.
Installation
1. Install the glass retaining clip.
^
Install the spacer.
^
Install the washer.
^
Tighten the Torx screws to 8 Nm (6 ft. lbs.).
2. Install the rear door window glass.
3. Install the guide channel lining.
4. Install the inner waist seal.
5. NOTE: Wedge the glass in this position.
Raise the rear door glass fully.
6. Install the rear door window motor and regulator assembly.