Range Rover Sport (LS) V8-4.4L (2009)
Installation
1. WARNING: If the roof opening panel motor is being replaced, the one touch and anti-trap function will become inoperative. Close the
roof opening panel and continue to hold the switch for a further 20 seconds to allow the sunroof to complete a full cycle. This will
complete the roof opening panel calibration routine and reset these functions.
Install the motor.
^
Tighten the Torx screws to 4 Nm (3 ft. lbs.).
2. With assistance, install the roof opening panel assembly.
^
Clean the component mating faces.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
3. Connect the roof opening panel motor electrical connector.
4. Connect the drain hoses.
^
Make sure the drain hoses are clear prior to connection.
^
Secure with the clips.
5. Install the headliner.
6. Connect the battery ground cable.
7. Using T4, configure a new roof opening panel motor.