Range Rover Sport (LS) V8-4.4L (2009)
/v8-4.4l/Page-601006.png)
31. Attach the wiring harness to the LH side of the engine
^
Secure the clips.
32. Attach the wiring harness to the RH side of the engine.
^
Secure the clips.
33. Install the power steering pump mounting bracket.
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
NOTE: Install a new gasket.
NOTE: Install a new 0-ring seal.
34. Install the engine front cover.
^
Clean the component mating faces.
^
Apply a 3 mm (0.118 in) diameter bead of sealant 12mm (0.47 in) long, to the 8 places indicated.
^
Install the gasket.
^
Install the 0-ring seal.
35. Evenly and progressively tighten the bolts in the sequence shown to 12 Nm (9 ft. lbs.).
36. Attach the engine wiring harness.
^
Secure the clips.
^
Tighten the bolt to 10 Nm (7 ft. lbs.).
NOTE: Install new seals.
37. Install the LH valve cover plug aperture seals.
NOTE: Install a new gasket.
NOTE: Apply two beads of silicone gasket sealant as shown on the illustration. The application of the sealant must be 3 mm (0.118 in) diameter
12 mm (0.47 in) long. Install the valve cover immediately after applying the sealant. The cover should be fitted directly to the head without smearing the
sealant or the seals.
