Range Rover Sport (LS) V8-4.4L (2009)
/v8-4.4l/Page-601009.png)
CAUTION: Under no circumstances should the crankshaft setting peg, 3O3-45, be used in the following operations, to restrain the crankshaft.
59. Using the special tools, tighten the crankshaft pulley bolt.
^
Tighten the crankshaft pulley bolt to 380 Nm (280 ft. lbs.).
^
Remove the special tools.
60. Install the oil filter housing.
^
Clean the component mating faces.
^
Install a new 0-ring seal.
^
Tighten the bolts to 20 Nm (15 ft. lbs.).
61. Install the engine oil filter.
^
Lubricate the oil filter seal with clean engine oil and tighten to 18 Nm (13 ft. lbs.).
62. Connect the EOP sensor electrical connector.
63. Connect the engine oil temperature sensor electrical connector.
64. Install the generator mounting bracket.
^
Tighten the 4 bolts to 45 Nm (33 ft. lbs.).
65. Install the generator.
^
Tighten the 3 bolts to 48 Nm (35 ft. lbs.).
^
Connect the electrical connector.
66. Connect the battery positive cable.
^
Tighten the nut to 10 Nm (7 ft. lbs.).
^
Install the battery positive cable cover.
67. Install the exhaust manifold heat shield.
^
Tighten the 2 bolts.
68. Install the accessory drive belt idler pulleys.
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
69. Install the coolant pump pulley.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
NOTE: Install new 0-ring seals.
70. Install the coolant manifold.
^
Clean the components.
^
Install the 0-ring seals.
^
Connect the 4 coolant hoses and install the clips.
^
Attach the wiring harness bracket.
^
Tighten the 2 bolts to 10 Nm (7 ft. lbs.).
71. Connect the ECT sensor electrical connector.
72. Install the cooling fan drive belt tensioner.
