Range Rover Sport (LS) V8-4.4L (2009)
Idler Pulley: Service and Repair
Accessory Drive Belt Idler Pulley
Service Repair No - 86.10.23
Removal
1. Disconnect the battery ground cable.
2. Remove the accessory drive belt.
3. Remove the accessory drive belt idler pulley.
^
Remove the bolt.
Installation
1. Install the accessory drive belt idler pulley.
^
Tighten the bolt to 25 Nm (18 ft. lbs.).
2. Install the accessory drive belt.
3. Connect the battery ground cable.
Specifications
Recommended Lubricant
HO2S threads ..................................................................................................................................... Use a high temperature resistant anti-seize compound
General Specifications
Exhaust manifolds .................................................................... Fabricated, air gapped with exhaust gas recirculation (EGR) tapping on left hand manifold
Exhaust system ................................................................................................................ Twin, stainless steel pipes throughout with stainless steel mufflers
Catalytic converters - type/location ............................. Close coupled cascade - located in each down pipe with pre and post catalyst sensors in both pipes