Range Rover Sport (LS) V8-4.4L (2009)
/v8-4.4l/Page-654006.png)
22. Remove the fuel injector housings.
^
Remove the 10 Torx screws.
^
Release the fuel injector housings and discard the gaskets.
Installation
1. Install the fuel injector housings.
^
Clean the component mating faces.
^
Install the gaskets.
^
Install the Torx screws.
2. Install the fuel rail.
^
Clean the component mating faces.
^
Install fuel injector O-ring seals.
^
Lubricate the O-ring seals with clean engine oil.
^
Tighten the 4 Torx bolts to 10 Nm (7 ft. lbs.).
3. Install the intake manifold MAP sensor housing.
^
Clean the component mating faces.
^
Tighten the 7 bolts to 10 Nm (7 ft. lbs.).
4. Install the intake manifold casting.
^
Clean the component mating faces.
^
Install the 4 bolts and tighten to 10 Nm (7 ft. lbs.).
5. Install the NVH pad to the RH side of the intake manifold.
6. Clean the components.
7. With assistance, install the intake manifold.
^
Install the gaskets.
^
Connect the mass air flow (MAF) sensor electrical connector.
^
Connect the brake booster vacuum hose to the intake manifold.
8. Install the bolts.
^
Evenly and progressively tighten the bolts to 20 Nm (15 ft. lbs.).
