Range Rover Sport (LS) V8-4.4L (2009)
/v8-4.4l/Page-725002.png)
^
Discard the gasket.
^
Loosen, but do not remove 2 bolts, securing the EGR pipe to the EGR valve.
10. Remove the exhaust manifold.
^
Remove the 8 bolts.
^
Collect the spacers and discard the bolts.
^
Remove the gasket/heat shield retaining bolt.
^
Discard the gasket/heat shield.
Installation
All vehicles
1. Clean the component mating faces.
2. Install the exhaust manifold.
^
Install the gasket/heat shield.
^
Tighten the heat shield bolt to 25 Nm (18 ft. lbs.).
^
Install, and lightly tighten the bolts.
^
Evenly and progressively, tighten the bolts in the sequence shown to 20 Nm (15 ft. lbs.).
3. Connect the EGR pipe and exhaust manifold flanges.
^
Install a new gasket.
^
Tighten the nuts to 25 Nm (18 ft. lbs.).
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
Left-hand drive vehicles
4. Install the steering column lower universal joint assembly.
^
Clean the component mating faces.
^
Install new patchlock bolts and tighten to 25 Nm (18 ft. lbs.).
All vehicles
5. NOTE: The heatshield consists of 3 parts.
Install the upper suspension arm and brake line heat shields.
