Range Rover Sport (LS) V8-4.4L (2009)
/v8-4.4l/Page-1900006.png)
33. Remove the evaporator core.
^
Release the temperature sensor.
Installation
1. Install the evaporator core.
^
Secure the temperature sensor.
2. Secure the heater core housing.
^
Install the clips.
^
Tighten the screws.
3. Connect the temperature sensor electrical connector.
4. Install the heater housing.
5. Passenger side: Install the heater housing to bulkhead Torx bolt and tighten to 6 Nm (4 lb.ft).
6. Driver side: Install the heater housing to bulkhead Torx bolt and tighten to 6 Nm (4 lb.ft).
7. Install the footwell ducts.
^
Tighten the Torx screws.
8. Connect the drain tubes to the heater housing.
9. Install the adapter panels.
^
Tighten the nuts to 6 Nm (4 lb.ft).
10. Secure the A/C lines to the bulkhead.
^
Clean the components.
^
Install new O-ring seals.
^
Tighten the bolt to 6 Nm (4 lb.ft).
11. Secure the A/C lines to the body.
^
Tighten the nut to 6 Nm (4 lb.ft).
12. Connect the bulkhead heater hoses.
13. With assistance, install the instrument panel.
^
Tighten the Torx bolts to 25 Nm (18 lb.ft).
14. Install the instrument panel carrier to bulkhead Torx bolt and tighten to 25 Nm (18 lb.ft).
15. Install the plenum chamber panel.
16. Secure the heater housing.
^
Tighten the screws.
17. Connect the steering column intermediate shaft.
^
Install the special bolt and tighten the new nut to 22 Nm (16 lb.ft).
