landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 4808 > < Diagram Information and Instructions
Page 2
background image

The sections in this Information are ordered to match the Global Outline numbering system. The Power and Ground distribution circuits can be found
under section 414-01, BATTERY, MOUNTING AND CABLES.

NOTE: Where circuit diagrams show more than one sub-system, the circuit will be located in the section that carries the first-named sub-system, for
example: Starting and Charging will be located under section 303-06 Starting System, since 'Starting' is the first-named sub-system.

Circuit sheet numbering

The figures in brackets to the left of the page number indicate a circuit sheet number and the total number of sheets per circuit, for example (01/05)
represents sheet 1 of 5.

Understanding the circuit diagrams

Components

After each component description, a translation code is displayed in brackets, for example: Starter relay (R102), Engine control-module (ECM)(D131).
The codes can be ignored.

NOTE: A dotted outline indicates that the component identified is not shown in its entirety.

Connectors

Connectors and header joints are identified by their corresponding connector number with a numbered suffix to indicate the pin-out detail of the wire, i.e.
C0292-1 identifies connector 292, pin number 1. Wire insulation colours are listed in a table at the end of this section. Where wires have a predominant
colour with a secondary colour tracer, the main colour is identified first, i.e. LGS - light green with a slate tracer.

Splices

The splices (and where appropriate, the header) circuit pages show the full interconnectivity of components and systems.

NOTE: The splice information shown on individual system circuits is not complete. Always refer to the splices circuit pages for complete information
for each splice.

Wire length (Splices, Power and Ground Distribution only)

The wire length (in millimetres) is displayed after the colour and cross sectional area; for example, SR,0.35,480. In this example, the figure, 480
indicates the approximate position of the harness splice is 480 mm from connector C2335.

Wire Types

Diagram Information and Instructions|Page 4808 > < Diagram Information and Instructions