Range Rover Sport (LS) V8-4.4L (2009)
8. NOTE: The rear camber adjustment bolts cannot be fully tightened with the rear wheels installed. Do not remove the rear wheels to tighten the
rear camber adjustment bolts until all other wheel alignment adjustments have been completed.
Adjust the rear camber.
^
Loosen the rear camber adjusting bolts.
^
Rotate the rear camber adjusting bolt until the correct value is obtained.
^
Repeat the above procedure for the other side.
^
Tighten the rear camber adjusting bolts.
9. Adjust the rear toe.
^
Loosen the toe link adjustment locking nut.
^
Rotate the toe link inner ball joint until the correct rear toe value is obtained.
^
Tighten the toe link adjustment locking nut to 130 Nm (96 lb.ft).
^
Repeat the above procedure for the other side.
^
Repeat the rear toe measurement.
10. CAUTION: Make sure the slip plates (turntables) are free to move before adjusting the geometry.
Adjust the front camber.
^
Loosen the lower arm front camber adjusting bolt.
^
Rotate the front camber adjusting bolt until the correct value is obtained.
^
Tighten the lower arm front camber adjusting bolt to 275 Nm (203 lb.ft).
^
Repeat the above procedure for the other side.