landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Relays and Modules - Steering and Suspension > < Initial Inspection and Diagnostic Overview|Page 4973
Page 4
background image

^

Loosen the track rod end locking nuts.

^

Rotate the track rods to adjust each individual front toe to the correct value.

^

Tighten the track rod end locking nuts to 53 Nm (39 lb.ft). 

15. Using the diagnostic equipment, return the vehicle to 'Normal Mode'.

^

Select the 'Configuration' tab

^

Select 'Set up and Configure'.

^

Select 'Air Suspension'.

^

Select 'Suspension Geometry Set Up'.

^

Select 'Normal Mode'.

^

Follow the on-screen instructions until the normal mode process has finished.

16. WARNING:  Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. 

Raise and support the vehicle.

17. Remove the rear wheels and tires.
18. Tighten the rear camber adjusting bolts to 133 Nm (98 lb.ft). 
19. Install the wheels and tires.

^

Tighten the wheel nuts to 140 Nm (103 lb.ft). 

20. Calibrate the steering angle sensor using T4.

Relays and Modules - Steering and Suspension > < Initial Inspection and Diagnostic Overview|Page 4973