Range Rover Sport (LS) V8-4.4L (2009)
5. Install a new halfshaft retaining nut and lightly tighten.
6. CAUTION: Ensure the ball joint seal is not damaged. A damaged seal will lead to the premature failure of the joint.
Connect the lower arm to the wheel knuckle.
^
Tighten the nut and bolt to 175 Nm (129 ft. lbs.).
7. CAUTION: Do not use a toe link bolt that has been installed more than 5 times. Check the bolt head for centre punch marks. A bolt head with 4
centre punch marks indicates the bolt has been installed 5 times and must be replaced.
Connect the toe link.
^
Tighten the bolt to 175 Nm (129 ft. lbs.).
^
Mark the bolt head with a centre punch, to indicate the number of times it has been used.
8. Install the wheel speed sensor.
^
Tighten the bolt to 9 Nm (7 ft. lbs.).
9. Locate the parking brake cable to the backplate.
^
Connect the cable to the brake shoe lever.
^
Tighten the coupling to 8 Nm (6 ft. lbs.).
^
Secure the parking brake cable to the lower arm.
10. Install the brake disc.
11. Tighten the halfshaft retaining nut to 350 Nm (258 ft. lbs.).
^
Stake the nut to the halfshaft.
12. Install the wheel and tire.
13. Carry out the wheel alignment procedure.