Range Rover Sport (LS) V8-4.4L (2009)
2. Verify torque of actuator arm flange bolts to actuator body. (Figure 1)
3. Check all Vehicle Dynamic system pipe routing:
^ Ensure no pipe-to-frame / body contact
^ Clear any stones / contamination from pipes and shields.
4. Using special tool 204-703 and 204-705, verify torque of front actuator clamp bolts. (Figure 2)
5. Refer to Workshop Manual (GTR) section 501-02: Front End Body Panels
(76.10.50) and install the engine undershield.
6. Roadtest vehicle to verify any repairs performed.
^ If noise is no longer evident, return vehicle to customer.
^ If noise is still present, continue to 'INSPECT REAR BODY MOUNT DAMPERS' below.
INSPECT REAR BODY MOUNT DAMPERS - REPLACE IF NECESSARY
1. Remove both rear body mount dampers.
2. Roadtest vehicle to determine if noise is still evident:
NOTE:
Vehicles with Dynamic Response must be fitted with rear body mount dampers prior to returning vehicle to customer.
^ If noise is no longer evident, replace the rear body mount dampers (to be carried out as a separate Warranty claim).
^ If noise is still present, install original rear body mount dampers; continue to 'INSPECT FRONT BODY MOUNT DAMPERS' below.
INSPECT FRONT BODY MOUNT DAMPERS
1. Remove both front body mount dampers.
2. Roadtest vehicle to determine if noise is still evident: