Range Rover Sport (LS) V8-4.4L (2009)
/v8-4.4l/Page-1775002.png)
10. Remove the fluid pump.
^
Remove the 3 bolts.
Installation
1. Install the fluid pump.
^
Clean the locating dowels.
^
Install and tighten the bolts to 22 Nm (16 ft. lbs.).
^
Prime the pump with clean fluid.
2. CAUTION: Make sure both O-ring seals are correctly installed on the high pressure union.
Connect the hoses.
^
Clean the component mating faces.
^
Lubricate and install new O-rings to the high-pressure union.
^
Tighten the union to 35 Nm (26 ft. lbs.).
^
Install the hose clip.
^
Remove the hose clamp.
3. Install the fluid pump drive pulley.
^
Install the Torx bolts, but do not tighten fully at this stage.
4. Install the belt.
5. Tighten the fluid pump drive pulley retaining bolts to 22 Nm (16 ft. lbs.).
6. Install the viscous fan assembly.
7. Install the fender splash shield.
8. Install the air cleaner assembly.
9. Refill the fluid reservoir.
10. Connect the battery ground lead, tighten the nut to 5 Nm (4 ft. lbs.).
11. Make sure there is fluid circulation through the reservoir.
^
Start the engine and allow to idle.
