Range Rover Sport (LS) V8-4.4L (2009)
Installation
1. CAUTION: Make sure the new Voss connector is installed and fully tightened with the alignment plug installed.
NOTE: New air suspension components are supplied with new Voss connectors tightened to the correct torque. Do not install new Voss
connectors if a new component is being installed.
Install new Voss connectors to the air suspension front solenoid valve block.
^
Tighten to 2.5 Nm (1.7 ft. lbs.).
2. NOTE: Make sure the valve block does not become detached during connection of the air lines.
Install the air suspension front solenoid valve block.
^
Secure the 3 valve block rubber insulators.
^
Connect the air lines into the Voss connector.
^
Pull on each air line to make sure it is fully installed into the Voss connector.
^
Connect the electrical connector.
3. Using T4, pressurize the air suspension.
4. Install the RH fender splash shield.
Air Suspension Rear Solenoid Valve Block
Air Suspension Rear Solenoid Valve Block
Service Repair No - 64.50.11
Removal
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the LH rear wheel and tire.
3. Using T4, depressurize the air suspension.
4. CAUTION: Before the disconnection or removal of any components, ensure the area around joint faces and connections are clean. Plug
any open connections to prevent contamination.
CAUTION: Visually inspect the air line ends for damage or wear. Repair or replace the air line as necessary.
NOTE: Note the air line fitted positions.
Disconnect 3 air lines from the rear valve block.
5. Disconnect the electrical connector.
6. Remove the rear valve block.
^
Release the valve block 3 rubber insulators.
7. Remove the Voss connectors from the air lines.
^
Remove and discard the collets and the unions.