Range Rover Sport (LS) V8-4.4L (2009)
/v8-4.4l/Page-1808005.png)
23. Remove the valve block to front stabilizer bar actuator pipe assembly.
Installation
1. Check the valve block O-rings and plastic spacer washers are correctly installed.
^
A: Backing rings (white)
^
B: Outer clamping ring
^
C: O-ring seals
^
D: Outer backing ring (Black)
2. Install the valve block to front stabilizer bar actuator pipe assembly.
^
Clean the components.
3. Connect the front actuator pipes to the valve block.
^
Remove the blanking caps from the ports.
^
Install 2 new nuts and tighten to 22 Nm (16 ft. lbs.).
^
Remove the container.
4. Attach the valve block to front stabilizer bar actuator pipe assembly mountings.
^
Tighten the 2 nuts and 1 bolt to 9 Nm (7 ft. lbs.).
5. Connect the fluid line to the reservoir.
^
Reposition the fluid line from the wheel arch area.
^
Install the clip.
^
Remove the container.
6. Install the air cleaner assembly.
7. Connect the high pressure line.
^
Remove the blanking caps from the ports.
^
Tighten the union to 21 Nm (15 ft. lbs.).
^
Remove the container.
8. Install the body mount.
9. Lower the body.
^
Remove the stands.
10. Install the body mount retaining bolts.
^
Tighten the 8 retaining bolts to 133 Nm (98 ft. lbs.).
11. Install the integrated body frame bracket.
^
Install the 3 bolts and tighten to 40 Nm (30 ft. lbs.).
