Range Rover Sport (LS) V8-4.4L (2009)
/v8-4.4l/Page-1282002.png)
^
Remove and discard the three bolts retaining the axle carrier to the axle.
^
Remove the axle carrier bushing bolt.
9. NOTE: Take note of the fitted position of the bush.
Using the special tools, remove the axle carrier bushing.
Installation
1. CAUTION: Make sure the bush is correctly aligned.
Using the special tools, install the axle carrier bushing.
2. Install the axle carrier.
^
Tighten the M14 bolt to 105 Nm (77 lb.ft).
^
Tighten the new axle carrier bracket bolts to 80 Nm (59 lb.ft), then a further 60 degrees.
3. Install the axle carrier bushing heat shield.
4. Install the stabilizer bar mounting.
^
Install the stabilizer bar bushing.
^
Install the clamp.
^
Install the bolts.
5. Install the stabilizer bar link.
