Range Rover Sport (LS) V8-4.4L (2009)
/v8-4.4l/Page-1306002.png)
Service Repair No - 47.11.16
Removal
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the wheel and tire.
3. Remove the halfshaft.
4. Clamp the halfshaft in a vise.
5. Remove and discard the CV joint boot retaining clamps.
6. Slide the CV joint boot along the halfshaft to gain access to the joint.
7. Using a drift against the inner part of the CV joint, remove the CV joint from the halfshaft.
^
Remove and discard the snap ring.
8. Remove the inner CV joint boot.
Installation
1. Clean the components.
2. Install the inner CV joint boot.
3. Install the inner joint.
^
Install a new snap ring.
^
Position the CV joint on the halfshaft, press the snap ring into it's groove and push the CV joint fully on to the halfshaft.
^
Pull on the CV joint to ensure the snap ring has fully engaged.
4. Pack the joint with the grease supplied.
5. Install the boot to the joint.
^
Secure with the new clamps.
6. Install the halfshaft.
7. Install the wheel and tire.
^
Tighten the wheel nuts to 140 Nm (103 lb.ft).
