Range Rover Sport (LS) V8-4.4L (2009)
/v8-4.4l/Page-1320002.png)
Installation
1. CAUTION: Make sure that when fully fitted, all seals protrude by the same amount.
CAUTION: Engage the selector lever with the groove in the piston rod.
Install the valve body.
^
Clean the component mating faces.
^
Install new seals.
^
Install a new seal block.
^
Tighten the Torx screws to 8 Nm (6 lb.ft).
2. Install a new electrical connector sleeve.
^
Secure with retainer.
3. Connect the electrical connector.
4. Install the fluid pan.
5. Calibrate a new main control valve body using T4.
