Range Rover Sport (LS) V8-4.4L (2009)
/v8-4.4l/Page-1401001.png)
Gear Sensor/Switch: Service and Repair
High/Low Range Sensor
Service Repair No - 41.30.07
Removal
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the crossmember.
3. CAUTION: To avoid damage to the joints or gaiters, do not allow the transmission to hang on the driveshafts.
Remove the mode sensor.
^
Lower the rear of the transmission for access.
^
Disconnect the electrical connector.
^
Remove the 2 Torx bolts.
Installation
1. To install, reverse the removal procedure.
^
Clean the components.
^
Tighten the Torx bolts to 10 Nm (7 lb.ft).
2. Install the crossmember.
3. Use T4 to re-calibrate a new mode sensor.
