Range Rover Sport (LS) V8-5.0L SC (2010)
Windshield Moulding / Trim: Customer Interest
Body - Upper Windshield Moulding Is Loose
No: LTB00322 (ISSUE 1)
27 OCT 2010
SECTION: 501
Upper Windshield Finisher Loose
AFFECTED VEHICLE RANGE:
CONDITION SUMMARY:
Situation:
The windshield finisher may be loose or a wind noise may be evident. This may be caused by body tolerances in relation to the upper windshield finisher
profile.
Action:
In the event of a customer concern of the above, refer to the Repair Procedure outlined below to inspect and either refit or replace the upper windshield
finisher.
PARTS:
TOOLS:
Refer to Workshop Manual (GTR) for any required special tools
WARRANTY:
NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always
refer to DDW to obtain the latest repair time.
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.
Normal Warranty policies and procedures apply.
REPAIR PROCEDURE
INSPECT AND REFIT / REPLACE UPPER WINDSHIELD
FINISHER