Range Rover Sport (LS) V8-5.0L SC (2010)
8. Inspect the inner and outer surfaces of the armrest mounting areas for cleanliness and damage. (Figure 4)
Clean as necessary.
9. Install the armrest to the seat.
NOTE:
Ensure the washers are fully located in the recess and do not move when installing the bolt.
10. Install the two wavy washers (AWR1 137) and Torx retaining screw into the recess. (Figure 5)
^
Tighten the screw to 12Nm (8.85 lbf ft).
11. Rotate the armrest up and down several times to verify operation.
NOTE:
Ensure the locating tang is correctly located in the armrest.