Range Rover Sport (LS) V8-5.0L SC (2010)
6. Inspect the general condition of the parking brake shoes, springs, and back plate:
^ Look for evidence of brake drag. This may be evident through excessive shoe lining or drum wear. There may also be evidence of heat build-up on the
shoes, drums or other internal components.
^ Ensure shoe hold-down clips are not damaged.
^ Remove any build-up of brake dust from the drum / shoe interface. ('A' - Figure 1)
^ Inspect shoe lining minimum thickness (2.0 mm [0.08 in]).
>
If there is evidence of damage due to heat build-up (brake shoe lining separation, significantly discolored discs), replace parking brake shoes,
discs, and / or hold-down clips as a separate claim.
CAUTION:
Do not over-compress the hold down clips during installation. Ensure parking brake shoes are held against the back plate.
NOTE:
Use Molyguard GS2039 (SYL500050) to grease the parking brake shoe / back plate platforms. ('B' - Figure 1)
7. Refer to Workshop Manual (GTR) Section 206-05 (70.40.09) to install the rear brake discs and calipers.
8. Install EPB 30A fuse 'LINK FL8' into the Battery Junction Box.
CAUTION:
The parking brake shoe and lining adjustment procedure must be carried out completely. Refer to SSM34964 for video clips of procedure.
9. Refer to Workshop Manual (GTR) Section 206-05: Parking Brake and Actuation (70.40.11) and perform the Parking Brake Shoe and Lining
Adjustment procedure.
Parking Brake Shoe Drag
PARKING BRAKE SHOE DRAG
INSPECT AND SERVICE PARKING BRAKE
CAUTION:
The EPB Module must be set into 'Mount Mode'; use IDS with DVD115 Patch File 4 or later.