Range Rover Sport (LS) V8-5.0L SC (2010)
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.
REPAIR PROCEDURE
CHECK FUEL TANK FLANGE / HARNESS CONNECTIONS
1. Refer to Workshop Manual, section 310-01: Fuel Tank and Lines, and use a suitable transmission jack, lower the fuel tank only enough to access the
top of the fuel tank.
2. Pull the flange / harness connector (C0114) upwards. (Figure 1)
3. Turn ignition 'ON'; observe fuel gauge operation.
^
If the fuel gauge drops to 0 (empty), turn ignition 'OFF', remove connector, and verify pin connections.
^
After repairing harness / connector pins, perform steps 2 - 3 again.
^
If concern is verified to be in the flange area and all connections are secure, replace the flange assembly.
^
After replacing flange assembly, perform steps 2-3 again.
If no fault is found, continue to FUEL TANK DIAGNOSIS AND TESTING below.
FUEL TANK DIAGNOSIS AND TESTING
1. Refer to Workshop Manual, section 310-01: Fuel Tank and Lines, and perform the appropriate diagnostic and repair procedure(s).
NOTE:
Not all derivatives will have the same number of connectors. Fuel tank module / sender components removed from fuel tank for clarity.