Range Rover Classic
76
CHASSIS AND BODY
16
REPAIR
REAR CORNER PANEL AND WING
Service repair no - 76.10.20 / 76.10.27
Remove
1. If applicable, remove 3 filler tube screws and fuel
filler flap.
See Fuel Filler Flap
2. Remove load space cover and spare wheel.
3. Remove 2 nuts and washers securing bumper
end cap to corner panel.
4. Remove bolt securing end cap to bumper.
5. Remove rear lamp assembly.
See
ELECTRICAL, Repair, Tail Lamp Assembly
6. Drill out pop rivets securing corner panel to
tailgate frame.
7. Remove 2 nuts and bolts securing wing[fender]
to ’D’ post, located beneath wheel arch.
8. Loosen nut and bolt retaining mud-flap bracket
to wing[fender].
9. Remove 5 screws securing wing[fender] to
bodyside panel. To access screw adjacent to ’D’
post, fold rear seat forward and remove seat
locking mechanism housing.
10. Remove rear wing[fender] with corner panel.
11. Remove 7 bolts, plain and spring washers
securing wing[fender] to corner panel.
Refit
12. Assemble corner panel to rear wing[fender] with
bolts. Align panels before tightening.
13. Coat underside of panels with body protection.
14. Fit assembly to vehicle. Align door shut face to
wing[fender] edge and corner panel to tailgate,
before tightening screws and fitting pop rivets.
15. Reverse removal procedure.