Workshop Manuals Factory service & repair Land Rover
01 4.0 & 4.6 Litre V8 Engine - 4th Edition02 03 04 05 INFORMATION06 07 08 GENERAL DATA09 10 11 12 TORQUE WRENCH SETTINGS13 SERVICE TOOLS14 15 16 17 18 DESCRIPTION AND OPERATION19 20 21 OVERHAUL
Land Rover Engine Overhaul Manual v8 4.0 4.621 · OVERHAUL
21 · General

Crankshaft - refit

Make
Land Rover
Model
Engines Engine Overhaul Manual v8 4.0 4.6
Section
Crankshaft - refit
OVERHAULCrankshaft - refit · page 1 of 2
Crankshaft - refit – Land Rover Engine Overhaul Manual v8 4.0 4.6

ENGINE

50

OVERHAUL

Crankshaft spigot bearing - renew

1. Carefully extract old spigot bearing.
2. Clean bearing recess in crankshaft.

3. Fit new bearing flush with, or to a maximum of

1.6 mm (0.06 in) below end face of crankshaft.

4. Ream bearing to correct inside diameter.

Spigot bearing inside diameter = 19.177 +
0.025 - 0.000 mm (0.75 + 0.001 - 0.000 in).

5. Remove all traces of swarf.

Crankshaft - refit

1. Clean main bearing caps, bearing shell

recesses and mating surfaces of cylinder
block.

CAUTION: Ensure bolt holes in cylinder
block and main bearing caps are clean
and dry.

2. Fit new upper main bearing shells, with oil

holes and grooves, in cylinder block, ensuring
flanged shell is fitted in centre position.

NOTE: If crankshaft has been reground
ensure appropriate oversize bearing shells
are fitted.

3. Lubricate main bearing shells with engine oil

and position crankshaft in cylinder block.

4. Fit new main bearing shells to bearing caps.
5. Lubricate main bearing shells with engine oil.
6. Fit numbers 1 to 4 main bearing caps ensuring

that reference marks made during dismantling
are aligned, fit and tighten main bearing cap
bolts to 5 Nm (4 lbf.ft).

NOTE: Do not fit side bolts at this stage.

Parts & tools for this job For Land Rover Engines

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.