Refitting Distributor for V8 Engine Overhaul - 35, 39, 42 Models
ENGINE
24
OVERHAUL
7. Remove tool LRT-12-183.
8. Fit and tighten screw securing dipstick tube to
LH rocker cover.
9. Fit dipstick.
Distributor - if fitted - refit
1. Ensure timing pointer is aligned with 3
°
mark
on crankshaft pulley and No.1 piston is on the
compression stroke.
2. Engine numbers without suffix B: Position oil
pump drive shaft tongue at the ten to four
position.
3. Lubricate a new ’O’ ring with engine oil and fit
to distributor.
4. Turn distributor drive until rotor arm is
approximately 30
°
anti-clockwise from No.1
spark plug segment in distributor cap.
5. Insert distributor into timing cover, engage
drive gear and push distributor down until ’O’
ring enters bore; position distributor clamp on
stud.